1.3英寸128×64 OLED,带SH1106G IC,30针,6800/8080接口,4线串行接口,I2C

SCE013001-V01为COG型OLED显示器,128×64分辨率,SH1106G集成电路,6800/8080接口,4线串行接口,I2C,30pin
  • 型号:

    SCE0130001-V01
  • Size (inch)尺寸(英寸):

    1.3寸
  • Resolution:

    128×64
  • Outline Dimension (mm):

    34.5×23×1.427
  • Viewing Area (mm):

    31.42×16.7
  • Active Area (mm):

    29.42×14.7
  • Interface:

    6800/8080 Interface,4-wire serial interface,I2C
  • IC Part No.:

    SH1106G
  • Color:

    Monochrome (White)
  • PIN:

    30
  • FPC type:

    Connector
  • 产品详细信息


Basic Information


Display Color:               White
Dot Matrix:                    128×64
Drive IC:                        SH1106G
Viewing Angle:              160°

Aperture rate:                83.3%
Interface:                       6800/8080 interface, 4 wire serial interface, I2C
Outline Dimension:        34.5×23×1.427
View area:                      31.42×16.7
PIN:                                30
FPC Type:                      Connector






Drawing





General Specification



ITEM SPECIFICATIONS  UNIT
 MODULE SIZE 34.5(W)x23.0(H)x1.427(D) mm
 VIEWING AREA 31.42 (W) x 16.7(H) mm
 ACTIVE AREA 29.42(W) x14.7(H) mm
 DOT SIZE 0.21(W) x0.21(H) mm
 DOT PITCH 0.23(W) x0.23 (H) mm
 ASSY.TYPE COG ---
 WEIGHT TBD




Interface Definition


PIN NO. SYMBOL TYPE FUNCTION DESCRIPTIONS
1 NC(GND) P It should be connected to external ground.
2 C2P I C1P/C1N-Pin for charge pump capacitor.
C2P/C2N-Pin for charge pump capacitor.
Connect to each other with a capacitor. They must be floated when the
Charge pump not use.
3 C2N
4 C1P
5 C1N
6 VBAT P Power supply for charge pump regulator circuit.
It must be connected to external source when charge pump is used. It must be float when charge pump is not used.
7 VSS P Ground pin. It must be connected to external ground.
8 VSS
9 VDD P Power pin for logic circuit. It must be connected to external source.
10 BS0 I

Interface selection pins.


11 BS1
12 BS2
13 CS# I Chip Select input pin. Active "L"
14 RES# I Hardware reset input pin. Active "L".
15 D/C# I This is Data/Command control pin.
When the pin is pulled HIGH, the data at D[7:0]  is data. When the pin is pulled LOW, the data at D[7:0] is command. In I2C mode, this pin acts as SA0 for slave address section.
When 3-wire serial interface is selected, this pin must be connected to VSS
16 R/W# I This is read/write control input pin.
8080: data write enable; 6800: read/write select pin.
When serial or I2C interface is selected, this pin must be connected to VSS.
17 E# I This is read/write control input pin.
8080: data read enable; 6800: read/write enable pin.
When serial or I2C interface is selected, this pin must be connected to VSS.
18 D0 I/O These are 8-bit bi-directional data bus to be connected to microprocessor's Data bus.
When serial interface mode is selected, D2 should be kept NC, D1 will be the serial data input: SDIN, D0 will be the serial clock input: SCLK.
When I2C mode is selected, D2, D1 should be tied together and serve as SDA and D0 is the serial clock input, SCL.
19 D1
20 D2
21 D3
22 D4
23 D5
24 D6
25 D7
26 IREF O Current reference for brightness adjustment.
This is segment output current reference pin. A resistor should be connected between this pin and VSS .Set the current at 12.5 uA maximum.
27 VCOMH O COM signal deselected voltage level.
A capacitor should be connected between this pin and VSS.
28 VCC P Power supply for OLED driving voltage. A capacitor should be connected between this pin and VSS, when charge pump is used.
It must be connected to external source when charge pump is not used.
29 NC
This is an analog ground pin. It should be connected to VSS externally.
30 NC(GND) P It should be connected to external ground.


相关产品
0.42寸 OLED

0.42英寸OLED图形液晶显示器

SCE042001-V01是COG型OLED显示器,分辨率72×40,SSD1306BZ IC,4线串行接口I2C,16针
0.66寸 OLED

0.66英寸OLED图形液晶显示器,64×48分辨率SSD1306BZ IC,28针

SCE066001-V01是COG型OLED显示器,分辨率72×40,SSD1306BZ IC,6800/8080接口,4线串行接口I2C,28针
0.69寸 OLED

0.69英寸OLED图形液晶显示器,分辨率为96×16 SSD1306BZ IC,14针

SCE069001-V01是一个COG型的OLED显示器,96×16分辨率,SSD1306BZ IC,接口I2C,14针
0.87寸 OLED

0.87英寸OLED图形显示器,128×32分辨率SSD1316Z IC,15针,4线SPI接口

SCE087001-V01是一个COG型的OLED显示器,128×32分辨率,SSD1306Z集成电路,4线SPI接口,15针
0.91寸 OLED

0.91英寸OLED图形显示器,128×32分辨率SSD1316BZ IC,14针,I2C接口

SCE091001-V01是一个COG型的OLED显示器,128×32分辨率,SSD1306BZ IC,I2C接口,14针
0.91寸 OLED

d带128×32分辨率SSD1316BZ集成电路、15针、4线串行接口的0.91英寸OLED图形显示器

SCE091003-V01是一种COG型OLED显示器,分辨率128×32,SSD1306BZ集成电路,4线串行接口,15针
0.96寸 OLED

0.96英寸OLED显示屏,128×64分辨率SSD1316BZ IC,30针,6800/8080接口,4线串行接口,I2C

SCE096002-V01是一个COG型的OLED显示器,128×64分辨率,SSD1306BZ IC,4线串行接口,30针
自定义OLED显示器

0.96英寸单oled,128×64,ssd1316bz集成电路,30针,6800/8080接口,4线串行接口,i2c

SCE096003-V01是一个COG型的OLED显示器,128×64分辨率,SSD1306BZ IC,4线串行接口,30针

网站地图XML工厂粤ICP备19093442号
版权所有 © 2015-2024 深圳市华之晶科技有限公司 所有权利保留

友情链接: New华之晶官网New华之晶英文站华之晶英文站干冰清洗机

欢迎光临华之晶

首页

产品

关于

联系